Disassemble Mira Shower Head – How To

The day might come when you want to Disassemble Mira Shower Head. Maybe you want to strip it because you want to clean it. Maybe you want to disassemble it because you need to replace the spray plate or seals. Or you may want to because of Poor spray pattern from the Cloud spray plate assembly.

Mira shower heads are designed to give a satisfactory shower over a range of pressures. These shower heads are suitable for pressures between 0.1 and 5.0 bar.

Cloud Spray Plate

Cleaning

Accessories

Disassemble Mira Shower Head.

Replacing the Spray plate or Seals.

Replacing the Spray plate or Seals
  1. Use a suitable tool to remove the grommets.
  2. Using the 2.5 mm hexagonal wrench (supplied), remove the screws.
  3. Separate the spray plate assembly into its individual components.
  4. Clean or replace components as necessary.Note! Make sure that the seals are located correctly.
  5. Reassemble the components in reverse order.

 

 

Replacing the Cloud Spray Plate Assembly.

Replacing the Cloud Spray plate Assembly
  1. Use a suitable tool to remove the grommets.
  2. Using the 2.5 mm hexagonal wrench (supplied), remove the screws.
  3. Separate the sprayplate assembly into its individual components.
  4. Replace the Cloud assembly sprayplate with the LC version.
  5. Reassemble the components in reverse order.

 

 

Disassemble Mira Shower Head – Cleaning.

Disassemble Mira Shower Head - Cleaning

Many household cleaners contain abrasives and chemical substances, and should not be used for cleaning plated or plastic fittings.These finishes should be cleaned with a mild washing up detergent or soap solution, and then wiped dry using a soft cloth.Use your thumb or a soft cloth to wipe any limescale from the soft nozzles and the front surface of the shower head spray plate.Important! The spray plate must be regularly cleaned to make sure that the shower head does not become blocked.

Use your thumb or a soft cloth to wipe any limescale from the soft nozzles.

 

 

Accessories.

Flow Regulator (12 L/min – Red) – 1641.059If your shower has no flow control, you may find operation of the shower on high pressure systems too forceful. Fitting a flow regulator in the shower head will reduce this.

Disassemble Mira Shower Head - Flow Regulator

Check valve (360m and 360r) – 1688.282

Mira Shower Head - Check Valve

Check valve (360i) – 1688.283

Mira Shower Head - Checkvalve (360i) - 1688.283

To comply with UK Water Regulations you must make provision to prevent the back flow of waste water through the shower.A hose retaining ring will allow compliance but may restrict full use of the hose.However, if your mixer shower is already fitted with single inlet check valves then fitting the extra shower head check valve will allow compliance without the need for the hose retaining ring.

MIRA SHOWER HEAD INSTALLATION & USER GUIDE

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Shower Eden - Turn your shower into bliss